Skip to content
Pickering Beach Garage Door SpecialistsRequest a visit
Open 24/7(289) 275-8485Call now
Person fitting a black strip along the bottom edge of a partly raised garage door, with a cracked strip lying on the floor. — Garage Door Bottom Seal Replacement, Ajax

Plan ahead Repairs · Ajax

Garage Door Bottom Seal Replacement in Ajax

There are mouse droppings along the wall behind the recycling bins, and at one bottom corner of the door the vinyl has a neat chewed notch the width of a thumb. Something has found its way in for the winter.

Call now · open 24/7(289) 275-8485

Request a visit

In plain words

The bottom seal is one part of a weather line that runs all the way round the door. Vinyl-finned stop moulding seals the jambs and header, the section joints have their own tongue-and-groove or shiplap seals, and a threshold seal glued to the floor can meet the bottom strip where a slab slopes the wrong way. Bottom seal replacement addresses the piece that takes the most punishment, and while the technician is there the rest of the perimeter is looked over. Where the side or top strips are torn or shrunk, doing them in the same visit gives a garage sealed on all four edges rather than three.

Sound familiar?

The strip under the door has gone as hard as a hose left out for ten summers. Press it and it does not give; bend it and it cracks. Where the door meets the floor it sits on the concrete without squashing at all.

How the visit goes

Garage Door Bottom Seal Replacement · Ajax

How the visit goes

Technician in a black cap holding a wrench to a coiled black spring above a paneled door, with a blue cooler behind. — Ajax
  1. 1

    How the opener meets the floor

    Before the old seal comes off, the technician watches the door close under power. Where the door stops, how firmly it lands, and whether the bottom section flexes as it settles all show how the down limit and force are set. A door that stops short leaves a gap regardless of the seal; one set to press hard flattens a new seal in a season and can bow the section. The current settings are noted so they can be reset once the new, taller strip is in place, and the photo eyes and reversing behaviour are checked at the same time so the finished door is tested against a known starting point.

  2. 2

    Fitting a new retainer where needed

    If the inspection found a retainer that is bent, corroded or spread open, it is replaced before the seal goes in. The old extrusion is unscrewed or its rivets drilled out, the bottom rail is cleaned and any rust treated, and a new aluminum retainer is fixed straight along the rail with fresh self-drilling screws, checked with a straightedge so the channels run true. Fastener heads are sealed against meltwater. On a door whose channel was moulded into a plastic bottom cap, a screw-on retainer is fitted over the rail so a standard seal can be used from now on.

  3. 3

    A record of the profile and size

    Before leaving, the technician tells you what went on the door: the seal profile, whether T, bead or bulb, its width and height, the material, the door width it was cut for, and whether the retainer was renewed. Write this on a card by the opener or inside the manual. Bottom seals wear out on a schedule of years rather than decades, and knowing the profile means the next one can be ordered and fitted without measuring from scratch. If a threshold seal was added, its length and type belong on the same card.

In the van

  • Silicone spray lubricant
  • Seal end caps
  • Nail-on vinyl strip for wood doors
  • Threshold seal and adhesive
  • Track clamps

What affects the quote

  1. 1

    Retainer replacement

    If the aluminum or plastic retainer is bent, spread open or corroded, a new extrusion, fasteners and the time to fit it straight along the rail are added as their own line.

  2. 2

    Door out of level

    If one corner of the door hangs low because of cable or spring tension, levelling the door is separate work done before the seal goes in and is priced on its own.

  3. 3

    Opener adjustment

    Resetting the down limit and force and repeating the reversing test after a taller seal is fitted is a short step that the quote names whenever the door has an opener.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 275-8485

Garage Door Bottom Seal Replacement: questions

Advice · (289) 275-8485

Does a wood garage door use the same kind of seal?

Usually not. Wood doors most often carry a flat or angled strip of vinyl or rubber nailed directly to the bottom rail, rather than a profile that slides into a retainer. Replacement means removing the old strip and nails, checking the rail for soft or cupped wood, and fastening a new strip so its lip angles outward and meets the floor along the full width. A retainer can be added to a sound rail if you prefer a channel seal.

What is a threshold seal, and when is it worth adding?

A threshold seal is a rubber or aluminum-backed strip glued to the garage floor along the line where the door closes. The door's bottom seal lands on it, and its raised outer edge turns water, wind-blown debris and small visitors back toward the driveway. It earns its place where the drive slopes toward the garage, the slab sits below the apron, or the floor edge is too uneven for the bottom seal alone to meet cleanly.

How long does a bottom seal last?

Several years is typical, with the range set by exposure. A door facing south or west, a threshold that is wet and salted all winter, and a seal that freezes to the floor a few times a season all shorten the life. A shaded door on a dry slab with a wipe of silicone each autumn can go much longer. The condition of the strip, rather than its age, is what to watch.

Garage Door Bottom Seal Replacement near you

Durham, Ontario

Ajax information

Town
Ajax, Durham, Ontario
In business
31 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

23%

Newer homes. About 23% of homes in Ajax were built in 1980 or earlier, according to the 2021 Census.

A newer door still under its first set of springs is a good candidate for preventive work: lubricating the torsion spring, checking the cable ends at the drums and confirming balance before the spring reaches its cycle limit, so the replacement is planned rather than forced by a broken spring.

65%

Mostly houses. Single-detached houses make up about 65% of homes in Ajax (2021 Census).

Households in detached homes often have several remotes, a keypad and a phone app between family members and their cars. We keep all of them programmed to the opener, replace the ones that have failed, and explain how to add a new one when a car changes hands.

Source: Statistics Canada, 2021 Census of Population

Open Ajax in Google Maps

Open 24/7

Request a visit

There are mouse droppings along the wall behind the recycling bins, and at one bottom corner of the door the vinyl has a neat chewed notch the width of a thumb.

Call now · open 24/7(289) 275-8485
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 31 years in business